It is a material developed by eSUN and LUVOCOM based on PA12, added with 15% carbon fiber, greatly enhances the strength, rigidity, and toughness of nylon, and can be used as a substitute for metal in many occasions; low water absorption rate, less affected by humidity and temperature for printing parts dimensions; self-lubricating and wear-resistant properties make it suitable for printing gears; high-temperature resistance, the continuous using temperature of parts can reach 120℃, short-term use temperature can reach 160℃; low shrinkage, not easy to warp and crack during printing, and the printing surface is matte and delicate.
Selling point
Low moisture absorption
High strength
High toughness
High rigidity
High impact resistance
Chemical resistance
Heat resistance
Abrasion resistance
High dimensional stability
Matte surface effect
Excellent printability
| Filament Properties Table | |
|---|---|
| 3D PRINTING FILAMENT | ePA12-CF |
| Density(g/cm3) | 1.24 |
| Heat Distortion Temp(℃,0.45MPa) | 94.1 |
| Melt Flow Index(g/10min) | 8.91(270℃/2.16kg) |
| Tensile Strength(MPa) | 108.18 |
| Elongation at Break(%) | 9.02 |
| Flexural Strength(MPa) | 116.58 |
| Flexural Modulus(MPa) | 3335 |
| IZOD Impact Strength(kJ/m2) | 11.33 |
| Durability | 10/10 |
| Printability | 8/10 |
| Recommended printing parameters | |
| Extruder Temperature(℃) | 270 – 300℃ Recommended temperature：280℃ |
| Bed temperature(℃) | 45 – 60°C |
| Fan Speed | 0% |
| Printing Speed | 40 – 100mm/s |
| Heated Bed | Optional |
| Recommended Build Surfaces | Masking paper, PVP solid glue, PEI |
Notes:
1. ePA12-CF needs to be dried (70℃/＞12H) before printing to achieve the best printing effect. It is recommended to use it with the eBOX cartridge when printing.
2. The ePA12-CF line has strong rigidity and is not easy to bend. In the feeding pipe, excessive bending of the filament should be avoided as much as possible.
3. ePA12-CF is very easy to grind nozzles and extruder gears. It is recommended to use hardened steel nozzles or ruby nozzles. If conditions permit, you can choose hardened steel extruder gears. If the printing time is long, the throat and nozzles need to be replaced.
4. It is recommended to set the skirt to make it better for taking the model from the forming plate.
Reviews
There are no reviews yet.